ASTM A1124/A1124M : 23

1.1 This specification covers deformed steel reinforcing bars with protective epoxy coating applied by the electrostatic spray method followed by a texturing surface treatment material.

1.2 Other organic coatings and texturing surface treatment materials may be used provided they meet the requirements of this specification.

1.3 Requirements for coatings are contained in Annex A1 of Specification A775/A775M.

1.4 Requirements for texturing surface treatment material are contained in Annex A1.

1.5 Requirements for patching material are contained in Annex A2 of Specification A775/A775M.

1.6 Guidelines for construction practices at the job-site are presented in Appendix X1.

1.7 This specification is applicable for orders in either inch-pound units (as Specification A1124) or SI units [as Specification A1124M].

1.8 The values stated in either inch-pound units or SI units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.9 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.10 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.