ASTM D3595 : 25

Standard Specification for Polychlorotrifluoroethylene (PCTFE) Extruded Plastic Film

Standard Details

1.1 This specification covers extruded film from PCTFE Fluoropolymer resins which are cited in Specification D1430.

1.2 This specification covers extruded film in thicknesses from 0.015 to 0.25 mm (0.0006 to 0.01 in.).

1.3 The values stated in SI units shall be regarded as the standard.

1.4 The following precautionary statement pertains only to the test methods portion, Section 9 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

Note 1: There is no known ISO equivalent to this standard.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.