logo

Standards Manage Your Business

We Manage Your Standards

ASTM

ASTM D2911/D2911M : 16

Standard Specification for Dimensions and Tolerances for Plastic Bottles

Standard Details

1.1 This specification covers the thread configuration and dimensions for finishes for plastic bottles with screw-type closures, having a maximum capacity of 18.9 L (5 gal) and a maximum bottle dimension of 305 mm (12 in.). Included are tolerances for bottle capacity and body dimensions.

1.2 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 The following precautionary caveat pertains only to the test methods portion, Section 8 of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1: There is no known ISO equivalent to this standard.

General Information

Status : Historical
Standard Type: Main
Document No: ASTM D2911/D2911M : 16
Document Year: 2016
Pages: 17
  • Section Volume:
  • 08.01 Volume 08.01 Plastics (I): C1147-D3159
  • ICS:
  • 55.100 Bottles. Pots. Jars

Life Cycle

Currently Viewing

Historical
ASTM D2911/D2911M : 16
Knowledge Corner

Expand Your Knowledge and Unlock Your Learning Potential - Your One-Stop Source for Information!

© Copyright 2024 BSB Edge Private Limited.

Enquire now +