ASTM B152/B152M : 00

1.1 This specification establishes the requirements for copper sheet, strip, plate, and rolled bar produced from the following coppers.

Copper UNS No.	Previous DesignationA	Type of Copper
C10100	OFE	Oxygen-free electronic
C10200B	OF	Oxygen-free without residualdeoxidants
C10300	...	Oxygen-free extra low phosphorus
C10400, C10500, C10700	OFS	Oxygen-free, silver bearing
C10800	...	Oxygen-free low phosphorus
C10910	...	Low oxygen
C11000B	ETP	Electrolytic tough pitch
C11300, C11400, C11600B	STP	Silver bearing tough pitch
C12000	DLP	Phosphorized, low residual phos-phorus
C12200B	DHP	Phosphorized, high residual phos-phorus
C12300	DPS	Phosphorized, silver bearing
C14200	DPA	Phosphorus deoxidized, arsenical
C14420	...	Tin bearing tellurium copper
C14530	...	Tin tellurium bearing copper

^AExcept Copper UNS No. C10300 (oxygen-free extra low phosphorus), No. C10800 (oxygen-free low phosphorus), and C10910 (low oxygen), these types of copper are classified in Classification B 224.
^BSAE Specification CA101 conforms to Copper UNS No. C10100; SAE Specification CA102 conforms to the requirements for Copper UNS No. C10200; SAE Specification CA110 conforms to the requirements for Copper UNS No. C11000; SAE Specifications CA113, CA114, and CA116 conform to the requirements for Copper UNS Nos. C11300, C11400, and C11600; SAE Specification CA120 conforms to Copper UNS No. C12000; and SAE Specification CA122 conforms to the requirements for Copper UNS No. C12200.

Note 1--Each of the coppers listed has unique properties that can make it suitable for specific applications. The purchaser should consult with the supplier to determine which copper would be best suited for the intended application.

Note 2--Copper UNS Nos. C10400, C10500, C10700, C11300, C11400, and C11600 identify coppers with specific silver content (see Table 1 ).

Note 3--This specification is not intended to cover material rolled to ounce-weight thicknesses. Such material is covered by Specification B370.
Plates for locomotive fireboxes are covered by Specification B 11.
Flat copper products with finished (rolled or drawn) edges (flat wire and strip) are also covered by Specification B72.

1.1.1 When no specific copper is identified in the contract or purchase order, the supplier may furnish product from any of the listed coppers.

1.2 The values stated in inch-pound units are to be regarded as the standard. The SI values given in parentheses are provided for information only.

1.3The following safety hazards caveat only pertains to the test method portion, Section 14 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.