ISO 11296-2:2018

Plastics piping systems for renovation of underground non-pressure drainage and sewerage networks — Part 2: Lining with continuous pipes

Standard Details

ISO 11296-2:2018, in conjunction with ISO 11296-1, specifies requirements and test methods for pipes and fittings which are part of plastics piping systems installed as continuous pipes in the renovation of underground non-pressure drainage and sewerage networks. It is applicable to polyethylene (PE) pipes of three different types:

- PE solid wall single layered pipes (nominal outside diameter, dn), including any identification stripes;

- PE pipes with co-extruded layers on either or both the outside and inside of the pipe (total outside diameter, dn), as specified in Annex A, where all layers have the same MRS rating;

- PE coated pipes (outside diameter, dn) having a peelable, contiguous, thermoplastics additional layer on the outside of the pipe ("coated pipe"), see Annex A.

In addition, ISO 11296-2:2018 covers:

- jointing of pipe lengths by means of butt fusion;

- fabricated and injection-moulded fittings made of PE.

General Information

Status : Published

Standard Type: Main

Document No: ISO 11296-2:2018

Document Year: 2018

Pages: 8

Edition: 1

Section Volume:
ISO/TC 138/SC 8. Rehabilitation of pipeline systems

ICS:
23.040.20 Plastics pipes
23.040.45 Plastics fittings
91.140.80 Drainage systems
93.030 External sewage systems

Life Cycle

Currently Viewing

Published

ISO 11296-2:2018

ISO 11296-2:2018

Standard Details

General Information

Life Cycle

Add Standards To Trackedge

Enquiry Form