logo

Standards Manage Your Business

We Manage Your Standards

IEC

IEC TS 62607-6-33:2025

Nanomanufacturing - Key control characteristics - Part 6-33: Graphene-related products - Defect density of graphene: electron energy loss spectroscopy

Standard Details

IEC TS 62607-6-33:2025, which is a Technical Specification, establishes a standardized method to determine the key control characteristic
• defect density (%, nm2)
of single layer graphene films by
• electron energy loss spectroscopy (EELS in transmission electron microscopy (TEM)).
This document outlines a method for quantitative measurement of defects in graphene at the nanoscale.
The method specified in this document is applicable to single layer graphene acquired via chemical vapour deposition (CVD), roll-to-roll production and exfoliated graphene flakes to estimate the defect density.
In order to obtain reliable data, it is essential that the procedure is consistent for each specified condition from the preparation of the TEM specimen to its observation. It is essential to maintain the spatial resolution below 1 nm by alignment of the beam. The dispersion value, which covers the entire energy loss near edge structure (ELNES) region of the carbon-K edge and maintains the highest energy resolution corresponds to 0,1 eV/ch. Defects in graphene are determined by measuring the spectral differences between sp2 hybridized and sp2/sp3 hybridized atoms, which are obtained by calculating the amplitude ratio of the π* and σ* orbital spectra.

General Information

Status : ACTIVE
Standard Type: Main
Document No: IEC TS 62607-6-33:2025
Document Year: 2025
Pages: 33
Edition: 1.0
  • Section Volume:
  • TC 113 Nanotechnology for electrotechnical products and systems

Life Cycle

Currently Viewing

ACTIVE
IEC TS 62607-6-33:2025
Knowledge Corner

Expand Your Knowledge and Unlock Your Learning Potential - Your One-Stop Source for Information!

© Copyright 2025 BSB Edge Private Limited.

Enquire now +