CSA C22.2 NO. 248.14:26

Preface This is the harmonized CSA Group and ULSE standard for Low-Voltage Fuses – Part 14: Supplemental Fuses . This is the third edition of CSA C22.2 No. 248.14, and third edition of UL 248-14. This edition of CSA C22.2 No. 248.14 supersedes the previous edition published in 2000. This edition of UL 248-14 supersedes the previous edition published in 2000. This harmonized standard was prepared by CSA Group and ULSE. The efforts and support of the Technical Harmonization Subcommittee, 32B, Fuses, Fuseholders, on the Harmonization of Electrotechnical Standards of the Nations of the Americas (CANENA) are gratefully acknowledged. This Standard is considered suitable for use for conformity assessment within the stated scope of the standard. This Standard was reviewed by the CSA Subcommittee on Fuses and Fuseholders, under the jurisdiction of the CSA Strategic Steering Committee on the Requirements for Electrical Safety, and has been formally approved by the CSA Technical Committee on Industrial Products. This Standard has been developed in compliance with Standards Council of Canada requirements for National Standards of Canada. It has been published as a National Standard of Canada by CSA Group. Scope 1.1 This Part is intended to be read together with the Standard for Low-Voltage Fuses – Part 1: General Requirements, hereafter referred to as Part 1. The titles of the Clauses in this Part correspond to the similarly titled Clauses in Part 1. The requirements of Part 1 apply unless modified by this Part. For the Part 1 requirements, refer to the Standard for Low-Voltage Fuses – Part 1: General Requirements, NMX-J-009-248/1-ANCE / CSA C22.2 No. 248.1 / UL 248-1. 1.2 This Part applies to supplemental fuses rated 60 A or less intended only for supplementary overcurrent protection where branch circuit or equivalent applications are not involved. DC ratings are optional.