CSA C22.2 NO. 56:26

Preface This is the eighth edition of CSA C22.2 No. 56, Flexible metal conduit and liquid-tight flexible metal conduit , one of a series of Standards issued by CSA Group under the Canadian Electrical Code, Part II. It supersedes the previous editions published in 2017, 2013, 2004, 1977, 1961, 1954, and 1938. The following are the major changes to this edition: a) updated material requirements in Clause 5.1.1.1to allow for the use of stainless steel for fabricating liquid-tight flexible metal conduit; b) added requirements for marking, test method, and criteria for the optional FT6 flame rating in Clauses 6.1.7.3and 7.2.5.3; c) added the requirement for marking of trade size to product markings of liquid-tight conduit in Clause 6.1.11; d) corrected errors in units of measurement and unit conversion in Clauses 7.2.6.1and Table 5; and e) updated Table 6to add requirements for jackets rated at 75 °C dry and 60°C oil. This Standard is considered suitable for use for conformity assessment within the stated scope of the Standard. This Standard was prepared by the Integrated Committee on Metal Conduit and Tubing, under the jurisdiction of the Technical Committee on Wiring Products and the Strategic Steering Committee on Requirements for Electrical Safety, and has been formally approved by the Technical Committee. This Standard has been developed in compliance with Standards Council of Canada requirements for National Standards of Canada. It has been published as a National Standard of Canada by CSA Group. Scope 1.1 This Standard applies to flexible metal conduit and liquid-tight flexible metal conduit, trade sizes 12 (3/8) to 103 (4), excluding 14 (7/16), intended for use as a metal raceway for the installation of conductors in accordance with the Canadian Electrical Code, Part I. In addition, this Standard applies to special purpose flexible metal conduit, trade sizes 10 (5/16) and 14 (7/16), intended for other applications requiring the conductors to be enclosed in a flexible metal raceway. 1.2 Liquid-tight flexible metal conduit covered by this Standard is provided with an overall thermoplastic jacket that is recognized for use at a maximum temperature of 60°C (140°F), 75°C (167°F), or 105°C (221°F). Note: For conduit sizes in this Standard, the metric trade designator is given first, with the trade size in inches following in parentheses. 1.3 The values given in SI units are the units of record for the purposes of this Standard. The values given in parentheses are for information and comparison only. 1.4 In this Standard, "shall" is used to express a requirement, i.e., a provision that the user is obliged to satisfy in order to comply with the Standard; "should" is used to express a recommendation or that which is advised but not required; and "may" is used to express an option or that which is permissible within the limits of the Standard. Notes accompanying clauses do not include requirements or alternative requirements; the purpose of a note accompanying a clause is to separate from the text explanatory or informative material. Notes to tables and figures are considered part of the table or figure and may be written as requirements. Annexes are designated normative (mandatory) or informative (non-mandatory) to define their application.