CSA C22.2 NO. 62275:25

Preface This is the harmonized ANCE, CSA Group, and ULSE standard for Cable management systems – Cable ties for electrical installations. It is the fourth edition of NMX-J-623-ANCE, CSA C22.2 No. 62275, and UL 62275. This edition of NMX-J-623-ANCE, CSA C22.2 No. 62275 and UL 62275 supersedes the previous edition published September 24, 2021. This harmonized standard is based on IEC Publication 62275: fourth edition, Cable management systems – Cable ties for electrical installations, issued November 2022. IEC 62275 is copyrighted by the IEC. This harmonized standard was prepared by the Association of Standardization and Certification (ANCE), CSA Group, and ULSE. The efforts and support of the CANENA Technical Harmonization Subcommittee 23A-62275 are gratefully acknowledged. This standard is considered suitable for use for conformity assessment within the stated scope of the standard. The present Mexican Standard was developed by the CT PIE-A from the Comite de Normalizacion de la Asociacion de Normalizacion y Certificacion, A.C., CONANCE, with the collaboration of the manufacturers and users. This standard was reviewed by the CSA Integrated Committee on Fittings, Hardware, and Positioning Devices, under the jurisdiction of the CSA Technical Committee on Wiring Products and the CSA Strategic Steering Committee on Requirements for Electrical Safety, and has been formally approved by the CSA Technical Committee. This standard has been developed in compliance with Standards Council of Canada requirements for National Standards of Canada. It has been published as a National Standard of Canada by CSA Group. Scope This document specifies requirements for metallic, non-metallic and composite cable ties and their associated fixing devices as a means used for managing or securing the wiring systems in electrical installations. Cable ties and associated fixing devices can also be suitable for other applications, such as support of wiring systems, and where so used, additional requirements can apply. 1DV.1 D2 Modify Clause 1 by replacing the first sentence with the following: This document specifies requirements for metallic, non-metallic, and composite cable ties and their associated fixing devices as a means used for managing, securing, or supporting the wiring systems in electrical installations in accordance with the Canadian Electrical Code (CE Code), Part I, CSA C22.1, in Canada, Standard for Electrical Installations, NOM-001-SEDE, in Mexico, and the National Electrical Code (NEC), NFPA 70, in the United States of America. This document does not contain requirements that evaluate any electrical insulation properties of the cable tie or mechanical protection of the cables provided by the cable tie. This document contains requirements for the mechanical interface of an adhesive fixing device to a solid surface. It does not consider the mechanical behaviour of the solid surface in itself. This document does not consider the mechanical interface, for example the mounting screw, of a fixing device other than adhesive to a solid surface. 1DV.2 D2 Modify Clause 1 by deleting the last paragraph and adding the following note: NOTE 1DV: This document considers the mechanical securement means of a fixing device to a surface when the means for securing is provided with the fixing device or is part of the fixing device, i.e., the push mount for an integral device (See 9.7.1, 9.7.2, and 9.7.3).