Knowledge Gateway
Unlock your learning potential with industry insights and standards that matter. Share your email to begin.
Unlock your learning potential with industry insights and standards that matter. Share your email to begin.
Status : Historical
Standard Type : Main
Document No : ASTM D3516 : 89(2019)e1
Document Year : 2019
Pages : 6
Edition : e1
Section Volume : Volume 06.03 Paint -- Pigments, Polymers, Resins, Naval Stores, Cellulosic Esters, and Ink Vehicles (06.03)
1.1 These test methods cover four ashing methods for cellulose. These are intended for use on unbleached and bleached cellulose in sheeted or bulk fiber form. Each one of the test methods has advantages, so that preference applications exist for all four.
1.2 The test methods appear as follows:
|
| Sections |
| Test Method A—Ash in Cellulose at 575°C | 6 to 11 |
| Test Method B—Sulfated Ash in Cellulose at 575°C | 12 to 17 |
| Test Method C—Ashing Cellulose by Schoniger Oxidation | 18 to 22 |
| Test Method D—Wet Ashing of Cellulose for Inorganics | 23 to 29 |
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see 20.6.1.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International StandardDetails, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.