Knowledge Gateway
Unlock your learning potential with industry insights and standards that matter. Share your email to begin.
General Information
Status : Historical
Standard Type : Main
Document No : ASTM D7233 : 08
Document Year : 2008
Pages : 3
1.1 This test method covers a procedure for determining the number of fractures present when paintbrush filaments are bent.
1.2 This method is applicable only to monofilaments with consistent longitudinal cross sectional dimensions commonly referred to as “level” filaments.
1.3 The values derived are in percent fractured filaments. For example, 2 fractured out of 18 filaments tested = 
or 11 %.
1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.