Standards Manage Your Business
We Manage Your Standards
Standards Manage Your Business
We Manage Your Standards
Standard Test Method for Determination of Loose and Tapped Bulk Densities of Small Quantities of Plutonium Oxide
1.1 This test method specifies a method for the determination of loose and tapped bulk density of plutonium oxide (PuO2) powder.
1.2 This test method is applicable when limited quantities of powder are available for performance of the measurements. Alternative test methods, such as Test Methods B527 or D7481, may be used when sufficient quantities are available.
1.3 This test method contains notes that are explanatory and are not part of the mandatory requirements of the method.
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Some specific hazards statements are given in Section 7 on Hazards.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International StandardDetails, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Currently Viewing
Expand Your Knowledge and Unlock Your Learning Potential - Your One-Stop Source for Information!
© Copyright 2024 BSB Edge Private Limited.
