Knowledge Gateway
Unlock your learning potential with industry insights and standards that matter. Share your email to begin.
Unlock your learning potential with industry insights and standards that matter. Share your email to begin.
Status : Active
Standard Type : Main
Document No : ASTM D2208 : 16(2023)
Document Year : 2023
Pages : 2
1.1 This test method covers the determination of the breaking strength of leather by the grab method. It is intended for use on light, soft leathers; boarded, sueded, or embossed leathers tested on a specimen in the form of a rectangle piece; narrow strap, welt, lace, and round belt leathers; or other leathers that cannot be accurately tested by Test Method D2209. This test method does not apply to wet blue.
1.2 The test method is not recommended for breaking loads over 500 lbf (2200 N) because of slippage of the specimen in the jaws.
1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International StandardDetails, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.