ASTM C1957/C1957M : 25 New ASTM DRM Policy

1.1 This practice covers procedures for onsite testing precast concrete water and wastewater structures using exfiltration acceptance limits to demonstrate the integrity of the installed materials, including structural integrity, and construction processes, with the exception of items included under the scope of Specification C1227 or C1613. Methods described herein are not intended to be used at the point of manufacture prior to delivery and assembly. Any disassembly or addition of components after performing this practice would invalidate the results.

1.2 The values stated in either inch pound or SI units are to be regarded separately as standard. The SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.