Knowledge Gateway
Unlock your learning potential with industry insights and standards that matter. Share your email to begin.
Unlock your learning potential with industry insights and standards that matter. Share your email to begin.
Status : Active
Standard Type : Main
Document No : ASTM C647 : 19(2025)
Document Year : 2025
Pages : 6
1.1 This guide identifies properties of mastics and coating finishes characterizing their performance as finishes for thermal insulation.
1.2 These properties relate to application and service. Each property is defined, and its significance and suggested test methods are described.
1.3 The properties appear in the following order in this guide.
|
| Paragraph |
| Application Properties | 6 |
| Consistency | 6.1 |
| Coverage | 6.2 |
| Build | 6.3 |
| Wet Flammability | 6.4 |
| Toxicity | 6.5 |
| Temperature and Humidity Range | 6.6 |
| Surface Wetting and Adhesion | 6.7 |
| Gap Filling and Bridging | 6.8 |
| Sizing and Sealing | 6.9 |
| Corrosion or Solvent Attack | 6.10 |
| Drying Time and Curing Time | 6.11 |
| Shrinkage | 6.12 |
| Storage Stability | 6.13 |
| Freeze-Thaw Stability | 6.14 |
| Service Properties | 7 |
| Specimen Preparation | 7.1 |
| Outdoor Durability | 7.2 |
| Environmental Resistance | 7.3 |
| Temperature Limits | 7.3.1 |
| Chemicals and Water Resistance | 7.3.2 |
| Mold and Mildew Resistance | 7.3.3 |
| Surface Flammability | 7.4 |
| Water-Vapor Transmission Rate | 7.5 |
| Adhesion | 7.6 |
| Damage Resistance | 7.7 |
| Impact Resistance | 7.7.1 |
| Abrasion Resistance | 7.7.2 |
| Stress Resistance | 7.8 |
| Flexure | 7.8.1 |
| Elongation | 7.8.2 |
| Color | 7.9 |
| Odor | 7.10 |
| Other Properties | 8 |
1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.