Knowledge Gateway
Unlock your learning potential with industry insights and standards that matter. Share your email to begin.
Unlock your learning potential with industry insights and standards that matter. Share your email to begin.
Status : Active
Standard Type : Main
Document No : AWWA C230 : 2026
Document Year : 2026
Pages : 28
This standard describes fabricated full-encirclement stainless-steel clamps for use in the repair or tapped service connection of potable water, wastewater, and reclaimed water piping systems. They are intended for nominal diameters 2 in. (50 mm) through 12 in. (300 mm). Full-encirclement repair clamps shall be manufactured completely from stainless steel or a combination of stainless-steel band and cast ductile-iron lug, along with stainless-steel or low-alloy carbon steel bolts and nuts, depending on service requirements and the purchaser’s documents. Tapped service connection outlets may be provided and shall range from 1/2-in. through 3-in. (12-mm through 75-mm) sizes. This standard does not cover stainless-steel tapping saddles, the seal of which is not fully circumferential. Repair clamps for larger than 12-in. (300-mm) nominal pipe diameters are available from various manufacturers but are not covered by this standard.
This standard may be referenced in purchaser’s documents for full-encirclement repair clamps and full-encirclement service connection clamps. The stipulations of this standard apply when this document has been referenced for full-encirclement repair clamps and full-encirclement service connection clamps only.