logo

Standards Manage Your Business

We Manage Your Standards

IEC

IEC 61191-6:2010 (EN-FR)

Printed board assemblies - Part 6: Evaluation criteria for voids in soldered joints of BGA and LGA and measurement method

Standard Details

IEC 61191-6:2010 specifies the evaluation criteria for voids on the scale of the thermal cycle life, and the measurement method of voids using X-ray observation. This part of IEC 61191 is applicable to the voids generated in the solder joints of BGA and LGA soldered on a board. This part of IEC 61191 is not applicable to the BGA package itself before it is assembled on a board. This standard is applicable also to devices having joints made by melt and re-solidification, such as flip chip devices and multi-chip modules, in addition to BGA and LGA. This standard is not applicable to joints with under-fill between a device and a board, or to solder joints within a device package. This standard is applicable to macrovoids of the sizes of from 10 µm to several hundred micrometres generated in a soldered joint, but is not applicable to smaller voids (typically, planar microvoids) with a size of smaller than 10 µm in diameter. This standard is intended for evaluation purposes and is applicable to research studies, off-line production process control and reliability assessment of assembly.

General Information

Status : ACTIVE
Standard Type: Main
Document No: IEC 61191-6:2010 (EN-FR)
Document Year: 2010
Pages: 76
Edition: 1.0
  • Section Volume:
  • TC 91 Electronics assembly technology
  • ICS:
  • 31.180 Printed circuits and boards

Life Cycle

Currently Viewing

ACTIVE
IEC 61191-6:2010 (EN-FR)
Knowledge Corner

Expand Your Knowledge and Unlock Your Learning Potential - Your One-Stop Source for Information!

© Copyright 2024 BSB Edge Private Limited.

Enquire now +