Knowledge Gateway
Unlock your learning potential with industry insights and standards that matter. Share your email to begin.
Unlock your learning potential with industry insights and standards that matter. Share your email to begin.
Status : Withdrawn
Standard Type : Main
Document No : ISO 15590-1:2009
Document Year : 2009
Pages : 32
Edition : 2
Section Volume : Pipeline transportation systems (ISO/TC 67/SC 2.)
ISO 15590-1:2009 is applicable to induction bends made from seamless and welded pipe of unalloyed or low-alloy steels. These are typically C-Mn steels or low-alloy steels that are appropriate for the corresponding level and grade of line pipe in accordance with ISO 3183.
ISO 15590-1:2009 specifies the requirements for the manufacture of two product specification levels (PSL's) of induction bend corresponding to product specification levels given for pipe in ISO 3183.
ISO 15590-1:2009 is not applicable to the selection of the induction bend product specification level. It is the responsibility of the purchaser to specify the PSL, based upon the intended use and design requirements; see also ISO 3183:2007, Introduction.
ISO 15590-1:2009 is not applicable to pipeline bends made by other manufacturing processes.