Knowledge Gateway
Unlock your learning potential with industry insights and standards that matter. Share your email to begin.
Unlock your learning potential with industry insights and standards that matter. Share your email to begin.
Status : Active
Standard Type : Main
Document No : ISO/IEC 14846:2003
Document Year : 2003
Pages : 64
Edition : 2.0
ISO/IEC 14846:2003 specifies the signalling protocol for the support of the Call Intrusion supplementary service (SS-CI) at the Q reference point between Private Integrated services Network eXchanges (PINXs) connected together within a Private Integrated Services Network (PISN).
SS-CI is a supplementary service which, on request from the calling user, enables the calling user to establish communication with a busy called user by breaking into an established call between the called user and a third user (unwanted user).
The Q reference point is defined in ISO/IEC 11579-1.
Service specifications are produced in three stages and according to the method specified in ETS 300 387. This International Standard contains the stage 3 specification for the Q reference point and satisfies the requirements identified by the stage 1 and stage 2 specifications in ISO/IEC 14845.
The signalling protocol for SS-CI operates on top of the signalling protocol for basic circuit switched call control, as specified in ISO/IEC 11572, and uses certain aspects of the generic procedures for the control of supplementary services specified in ISO/IEC 11582.
ISO/IEC 14846:2003 also specifies additional signalling protocol requirements for the support of interactions at the Q reference point between SS-CI and other supplementary services and ANFs.
NOTE Additional interactions that have no impact on the signalling protocol at the Q reference point can be found in the relevant stage 1 specifications.
ISO/IEC 14846:2003 is applicable to PINXs which can interconnect to form a PISN.