CSA B45.11:17/IAPMO Z401:2017 (R2026)

Preface This is the second edition of CSA B45.11/IAPMO Z401, Glass plumbing fixtures. It supersedes the previous edition published in 2011. This edition include the following changes: a) a revised thermal shock test; and b) a revised warpage test procedure to be consistent with other standards. This Standard is considered suitable for use for conformity assessment within the stated scope of the Standard. This Standard was prepared by the CSA Technical Committee on Plumbing Fixtures and the IAPMO Plumbing Standards Committee. The CSA Technical Committee operates under the jurisdiction of the CSA Strategic Steering Committee on Construction and Civil Infrastructure. This Standard has been formally approved by the CSA Technical Committee and the IAPMO Plumbing Standards Committee. This Standard was approved as an American National Standard by the American National Standards Institute on July 18, 2017. Scope 1.1 This Standard covers lavatories and sinks made of glass and specifies test methods, performance requirements, and marking requirements. 1.2 In this Standard, "shall" is used to express a requirement, i.e., a provision that the user is obliged to satisfy in order to comply with the standard; "should" is used to express a recommendation or that which is advised but not required; and "may" is used to express an option or that which is permissible within the limits of the Standard. Notes accompanying clauses do not include requirements or alternative requirements; the purpose of a note accompanying a clause is to separate from the text explanatory or informative material. Notes to tables and figures are considered part of the table or figure and may be written as requirements. Annexes are designated normative (mandatory) or informative (non-mandatory) to define their application. 1.3 SI units are the units of record in Canada. In this Standard, the inch/pound units are shown in parentheses. The values stated in each measurement system are equivalent in application; however, each system is to be used independently. Combining values from the two measurement systems can result in non-conformance with this Standard. All references to gallons are to US gallons. For information on the conversion criteria used in this Standard, see Annex A.