ISO 10846-2:2008

Acoustics and vibration — Laboratory measurement of vibro-acoustic transfer properties of resilient elements — Part 2: Direct method for determination of the dynamic stiffness of resilient supports for translatory motion

Standard Details

ISO 10846-2:2008 specifies a method for determining the dynamic transfer stiffness for translations of resilient supports, under specified preload. The method concerns the laboratory measurement of vibrations on the input side and blocking output forces and is called “the direct method.” The method is applicable to test elements with parallel flanges (see Figure 1).

Resilient elements, which are the subject of ISO 10846-2:2008, are those which are used to reduce

the transmission of vibration in the lower part of the audible frequency range (typically 20 Hz to 500 Hz) to a structure which may, for example, radiate unwanted fluid-borne sound (airborne, waterborne or others), and

the transmission of low-frequency vibrations (typically 1 Hz to 80 Hz), which may, for example, act upon human subjects or cause damage to structures of any size when vibration is too severe.

General Information

Status : Published

Standard Type: Main

Document No: ISO 10846-2:2008

Document Year: 2008

Pages: 28

Edition: 2

Section Volume:
ISO/TC 43/SC 1. Noise

ICS:
17.140.01 Acoustic measurements and noise abatement in general

Preview Document

Life Cycle

Currently Viewing

Published

ISO 10846-2:2008

WITHDRAWN

ISO 10846-2:1997

ISO 10846-2:2008

Standard Details

General Information

Life Cycle

Add Standards To Trackedge

Enquiry Form